Reference Guide

400 Brocade Fabric OS Command Reference

53-1004112-02

haSyncStart

Enables High Availability state synchronization.

Synopsis hasyncstart

Description Use this command to enable the High Availability (HA) state synchronization.

After issuing haSyncStop, the switch does not go back to sync start unless you perform one of the following

actions: reboot the active CP, reboot the standby CP, insert a new standby CP (blade), or issue the haSyncStart

command The time it takes for the HA sync to complete depends on the system configuration. The HA sync

timeout is set to 10 minutes.

Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric

OS Commands" and "Command Availability" for details.

Examples To enable the HA state synchronization:

switch:admin> hasyncstart