Reference Guide

Brocade Fabric OS Command Reference 401

53-1004112-02

haSyncStop

Disables High Availability state synchronization.

Synopsis hasyncstop

Description Use this command to temporarily disable High Availability (HA) synchronization.

After issuing haSyncStop, the switch does not go back to sync start unless you perform one of the following

actions: reboot the active CP, reboot the standby CP, insert a new standby CP (blade), or issue the haSyncStart

command The time it takes for the HA sync to complete depends on the system configuration. The HA sync

timeout is set to 10 minutes.

Notes Disabling HA synchronization may cause failover to be disruptive.

The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric

OS Commands" and "Command Availability" for details.

Operands None

Examples To disable the HA state synchronizing process:

switch:admin> hasyncstop

SEE ALSO haFailover, haShow, haSyncStart