Reference Guide

426 Brocade Fabric OS Command Reference
53-1004112-02
ipAddrSet
-slot number
On a chassis with a blade processor (BP), specifies the slot number. On standalone
platforms with a hidden BP, such as the AP76500, this parameter is not accepted.
-ipv6 [-auto | -noauto]
Enables or disables stateless IPv6 autoconfiguration on a switch or chassis. When
autoconfiguration is enabled, the host automatically performs configuration of IPv6
addresses and periodic nondisruptive reconfiguration. By default, autoconfiguration is
disabled.
-ls FID
Specifies the logical fabric ID for which to configure an IPFC network interface. The FID is a
decimal number. A switch that is not in Virtual Fabric mode uses the -ls parameter with FID
128 (the effective, single Logical Fabric number on such switches) to set the IPv4 FC
address. Note that setting the IP address for the logical switch is only for the IPFC interface,
not for the Ethernet interface.
--add
Assigns a specified IPv4 FC address and prefix to the logical switch instance
represented by the specified FID. This command replaces any existing FC IPv4
address.
IPv4_address/prefix
Specifies the IPv4 address and prefix for the IPFC network interface. The IP Address is
represented by a dotted decimal number, followed by a slash and a prefix. This
operand is required with the --add option.
--delete
Deletes the IPv4 FC address and prefix from a logical switch.
-ls IFID
Specifies the fabric ID that identifies the logical switch for which to delete the FC IPv4
address and prefix. This operand is required when deleting an FC IPv4 address from a
logical switch. On a switch that is not in Virtual Fabric mode, use the -ls parameter with
FID 128 (the effective, single Logical Fabric number on such switches) to delete the
IPv4 FC address.
When used interactively to configure IPv4 addresses on a modular platform, ipAddrSet prompts for the following
parameters:
-cp cp_number
Specifies the managed entity as a CP. Valid values include the following:
0
Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address and host name of
CP0.
1
Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address and host name of
CP1.
-chassis
Specifies the managed entity as the chassis.