Reference Guide

Brocade Fabric OS Command Reference 431
53-1004112-02
ipAddrShow
Local IPv6 addresses display the following identifiers:
• IP Address type:
- static - A statically configured IPv6 address.
- stateless - Acquired through stateless autoconfiguration.
• IP Address state:
- tentative
- preferred
- deprecated
Refer to the RFC 2462 specification for more information.
On modular platforms with intelligent blades, the addresses configured for each slot can be shown with the -slot
option. On standalone platforms, all command options are ignored.
Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric
OS Commands" and "Command Availability" for details.
Operands This command has the following operands:
-cp cp_number
On dual-CP systems, specifies the CP card number to be displayed (0 or 1).
-chassis
On dual-CP systems, displays the IP addresses for the chassis.
-slot slot
Specifies the slot for a blade.
-eth0 | -eth1 | -gate
For a specified slot, shows only the selected Ethernet interface or the gateway . This
operand is optional with the -slot option.
Examples To display the IP addresses on a standalone switch:
switch:admin> ipaddrshow
SWITCH
Ethernet IP Address: 10.20.21.204
Ethernet Subnetmask: 255.255.240.0
Gateway IP Address: 10.20.16.1
DHCP: Off
IPv6 Autoconfiguration Enabled: Yes
Local IPv6 Addresses:
dhcpv6 fd00:60:69bc:82:a6f3:568b:a9cc:a149/64 preferred
stateless fd00:60:69bc:82:205:33ff:fe94:771f/64 preferred
IPv6 Gateways:
fe80::21b:edff:fe0b:2400
fe80::21b:edff:fe0b:7800
DHCPv6: On