Reference Guide

Brocade Fabric OS Command Reference 509
53-1004112-02
mapsConfig
-type member_type
Specifies the type of elements on which to pause monitoring. Valid types include the
following:
port
The elements are FC ports.
circuit
The elements are FCIP circuits.
sfp
The elements are SFP transceivers.
-members member_list
Specifies the specific elements on which to pause or continue monitoring. The member list
must be enclosed in double quotation marks and can consist of the following:
Port and SFP groups:
• A single port, for example, "8" or "2/8" on bladed systems.
• A port range where the beginning and end port are separated by a dash, for
example, "8-13" or "2/8-13" on bladed systems.
• A set of ports and port ranges separated by commas, for example, "3,5,7-10,15"
or "2/3,2/5,3/7-10,4/15" on bladed systems.
Circuit groups:
• A single circuit in VE_Port/circuit format, for example, "33/5".
• A circuit range in VE_Port/circuit format, for example, "33/1-3".
• A set of circuits separated by commas, for example, "33/1-3,33/5".
--actions actions_list
Specifies a comma-separated list of all of the actions that are allowed globally on the switch.
Any actions listed for a specific rule must also be listed here to take effect. Valid actions
include the following:
raslog
Generates a RASLog message.
decom
Decommissions the port. Use this action along with fence.
fence
Fences the port, if port fencing is enabled. Port fencing takes the ports offline if the rule
thresholds are exceeded. This action is valid only on conditions that are evaluated on ports.
snmp
Generates an SNMP trap.
email
Sends information about a switch event to a specified e-mail address.
sfp_marginal
Sets the state of the affected SFP transceiver to marginal. This action is valid only if the
monitoring system (specified by the monitor operand in the mapsRule command) is one of
the switch policy status monitoring systems: CURRENT, RXP, TXP, VOLTAGE,
SFP_TEMP.