Reference Guide

510 Brocade Fabric OS Command Reference
53-1004112-02
mapsConfig
sddq
Isolates the slow-drain flows to a low priority VC from the existing VC (medium or high) thus
freeing up the resources for the regular flows in the existing VC. Th slow drain device
quarantine (SDDQ) feature is not supported in the Access Gateway mode.
fms
Notifies the configured MAPS threshold events to the FICON Management Server (FMS).
toggle
Enables port toggling to recover a port from bottleneck condition caused by the target
device. Port toggle is supported only for the F_Ports.
none
No actions are allowed on the switch. Specifying this option allows you to turn off all
notifications.
The actions SW_CRITICAL and SW_MARGINAL are always enabled by default.
--emailcfg
Specifies the configuration for e-mail notifications, if email is a triggered action. You can
configure a relay host IP address using the relayConfig command.
-address email_address
Specifies the e-mail address to which the notifications are sent. You can configure up to 5
e-mail addresses as the alert message's receiver. Multiple e-mail addresses must be
separated by a comma and each e-mail address can be up to a maximum length of 128
bytes. The e-mail address must conform to standard syntax: [e-mail]. Invalid
e-mail addresses are rejected. "NONE" is the default address and a valid input parameter.
--testmail
Sends the test e-mail with the default subject and message along with the switch name in
the message. The command fails if the e-mail address is not configured.
-subject subject
Specifies the user-defined subject line for the test e-mail. This operand is optional.
-message msg
Specifies the user-defined message for the test e-mail. This operand is optional.
--import
Imports a flow from Flow Vision into MAPS.
flow_name
Specifies the name of a flow to be imported. The flow name must be defined in Flow Vision.
This operand is required.
-force
Imports a flow with the same name as the previously imported flow. This operand is
optional. When a flow that was imported into MAPS is deleted in Flow Vision, all members
of the group corresponding to that flow are automatically deleted from MAPS. If the same
flow is created again, it will not automatically be reimported into MAPS, and importing this
flow using the --import option fails unless you use the -force option.