Reference Guide

532 Brocade Fabric OS Command Reference
53-1004112-02
mapsRule
le
Less than or equal to
g
Greater than
ge
Greater than or equal to
eq
Equal to
value
Specifies the threshold value. Valid values include the following:
• For numerical values: 1-9999.
• For percentage values: 1-100.
• For FRU states: ON, OFF, IN, OUT, or FAULTY.
• For temperature monitoring: IN_RANGE or OUT_OF_RANGE.
• For FPI states: IO_FRAME_LOSS, IO_PERF_IMPACT, IO_LATENCY_CLEAR.
• For Ethernet port state: UP or DOWN
action
Specifies a comma-separated list of actions to be taken if the specified condition is
evaluated to be true. The action is not taken unless it is also specified globally, using the
mapsconfig --actions command. Valid actions include the following:
raslog
Generates a RASLog message.
decom
Decommissions the port. Use this action along with fence.
fence
Fences the port, if port fencing is enabled. Port fencing takes the ports offline if the
user-defined thresholds are exceeded. This action is valid only on conditions that are
evaluated on ports.
snmp
Generates an SNMP trap.
email
Sends information about a switch event to a specified e-mail address.
sw_critical
Sets the state of the affected switch to critical. This action is valid only if the monitor
operand is one of the switch policy status monitoring systems.
sw_marginal
Sets the state of the affected switch to marginal. This action is valid only if the monitor
operand is one of the switch policy status monitoring systems.
sfp_marginal
Sets the state of the affected SFP transceiver to marginal. This action is valid only if the
monitor operand is one of the switch policy status monitoring systems.