Reference Guide
628 Brocade Fabric OS Command Reference
53-1004112-02
portCfg
enable
Re-enables the inband management interface at the specified GbE Port after it has been
disabled. The interface is by default enabled when it is created.
mgmtroute
Configures the management route for the inband management interface (needed only if the
management interfaces are on different subnets). The syntax for mgmtroute is as follows:
mgmtroute ge_port [options] destination_ip_address
Valid options and arguments for mgmtroute include the following:
create
Creates a management route for a specified destination IP Address. The following operands
are required:
dest_IPv4_addr
Specifies the destination IP address for the management route in IPv4 format.
netmask
Specifies the subnet mask for the IPv4 address in a.b.c.d format.
gateway
Specifies the IP address of an IP router that can route packets to the destination IP
address.
delete
Deletes a management route for a specified destination IP Address. The following operands
are required.
dest_IPv4_addr
Specifies the destination IP address for the management route in IPv4 format.
netmask
Specifies the subnet mask for the IPv4 address in a.b.c.d format.
sla
Creates. modifies, or deletes an SLA session. For more information on the SLA feature,
refer to the Fabric OS Extension Administration Guide.
This command supports create, modify, and delete options only. The syntax for portcfg sla
is as follows:
portcfg sla name option [args]
Valid options and arguments for sla include the following:
create
Creates an SLA session with the specified name. You must create an SLA session at each
end of the circuit, but the session names need not match.
modify
Modifies the specified SLA session.
name
Specifies the name of the SLA.