Reference Guide

ManualsBrandsDell ManualsAccess PlatformsBrocade G620

651

652

653

654

655

656

657

658

659

660

634 Brocade Fabric OS Command Reference

53-1004112-02

portCfg

To enable the autonegotiation of a 1GbE port:

switch:admin> portcfg autoneg 1/ge2 --enable

Operation Succeeded

switch:admin> portshow autoneg 1/ge2

Auto-Negotiation Configuration:

Port: 1/ge2

Auto-Negotiate: Enabled

To create an SLA session:

switch:admin> portcfg sla netA create --loss 0.5 \

--runtime 15 --timeout 60

Operation Succeeded

Function Configure tunnels, circuits, and management interfaces on the Brocade 7840 switch and Brocade FX8-24 and

Brocade SX6 extension blades.

Synopsis portcfg action [slot/]ve_port options arguments

Description Use this command to configure FCIP tunnels and FCIP circuits on the Brocade 7840 switch, and the Brocade

FX8-24 and Brocade SX6 extension blades only. The FCIP tunnels on the local and remote ports act as Virtual

E_Ports (VE_Ports) connecting the local and remote fabrics. The following operations can be performed with this

command:

• portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels.

- Configure a tunnel with the FCIP FastWrite feature.

- Enable or disable Tape Pipelining.

- Configure the compression options.

- Configure an IPsec-enabled tunnel.

- Configure VLAN tagging on the default FCIP circuit. This option is supported on Brocade FX8-24 blade

only.

- Configure Differentiated Services Code Point (DSCP) markings.

- Set the committed rate or minimum and maximum rates for the default circuit.

- Configure a tunnel for FICON emulation.

• portcfg fcipcircuit - Create, modify, and delete additional FCIP circuits.

- Set or modify the committed rate or minimum and maximum rates for the circuit.

- Configure or change VLAN tagging on the default circuit.

- Set or modify additional circuit parameters.

Notes You can configure up to 20 tunnels on the Brocade 7840 switch, and on the Brocade FX8-24 and Brocade SX6

extension blades.

Operands This command has the following operands:

slot

For bladed systems only, specifies the slot number of the port to be configured, followed by

a slash (/).