Reference Guide

644 Brocade Fabric OS Command Reference
53-1004112-02
portCfg
--dscp-high dscp
Specifies the DSCP value for FC High Priority. The range is 0 to 63. The default value
is 0.
--dscp-medium dscp
Specifies the DSCP value for FC Medium Priority. The range is 0 to 63. The default
value is 0.
--dscp-low dscp
Specifies the DSCP value for FC Low Priority. The range is 0 to 63. The default value
is 0.
--dscp-ip-high dscp
Specifies the DSCP value for IP High Priority. The range is 0 to 63. The default value is
0. This parameter is supported only on Brocade 7840 switch and the Brocade SX6
extension blade.
--dscp-ip-medium dscp
Specifies the DSCP value for IP Medium Priority. The range is 0 to 63. The default
value is 0. This parameter is supported only on Brocade 7840 switch and the Brocade
SX6 extension blade.
--dscp-ip-low dscp
Specifies the DSCP value for IP Low Priority. The range is 0 to 63. The default value is
0. This parameter is supported only on Brocade 7840 switch and the Brocade SX6
extension blade.
delete tunnel_ID
Deletes the specified extension tunnel. This command deletes all associated circuits created
with the fciptunnel or fcipcircuit commands. Use the portShow command to display all
tunnels and their associated circuits.
fcipcircuit
Creates an extension circuit on an existing tunnel. Use this command to configure additional
circuits. The circuit-specific parameters are optional. The syntax for portcfg fcipcircuit is as
follows:
portcfg fcipcircuit [slot/]ve_port option circuit_ID options [arguments] [optional_arguments]
The following options and arguments are supported with fcipcircuit:
create circuit_ID -D | --remote-ip remote_ip_addr -S | --local-ip local_ip_addr -b | --min-comm-rate value
in kbps
-B|--max-comm-rate value in kbps [circuit_arguments]
Creates an extension circuit. You must specify the following parameters when creating an
additional circuit:
circuit_ID
Specifies a numeric identifier for the circuit. The circuit ID is an integer value between
0-9 for both the Brocade FX8-24, and 0-7 for the Brocade 7840 switch.
-D | --remote-ip remote_ip_addr
Specifies the IP address for the remote end of the circuit.