Reference Guide

Brocade Fabric OS Command Reference 659

53-1004112-02

portCfgDefault

Resets the port configuration to factory default value.

Synopsis portcfgdefault [slot/][ge]port

portcfgdefault --help

Description Use this command to reset all configuration values on a specified port to their factory defaults. This command

persistently disables ports capable of routing, which is the factory default value. Use the portCfgShow command

to display the port configuration.

This command does not change the state of a port. To change the state of an E_Port, use either

switchDisable/switchEnable or portDisable/portEnable.

When this command is used to reset an F_Port in an Access Gateway, that F_Port is unmapped from its mapping

to an N_Port.

Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric

OS Commands" and "Command Availability" for details.

Operands This command has the following operands:

slot

For bladed systems only, specifies the slot number of the port to be reset, followed by a

slash (/).

port

Specifies the number of the port to be reset, relative to its slot for bladed systems. Use

switchShow to list of valid ports.

--help

Displays the command usage.

Examples To reset a port to factory defaults:

switch:admin> portcfgdefault 1/3

To reset a GbE port to factory defaults:

switch:admin> portcfgdefault 8/ge1

SEE ALSO portCfgEport, portCfgGport, portCfgLongDistance, portCfgLport, portCfgPersistentDisable,

portCfgPersistentEnable, portCfgShow, portCfgSpeed, portCfgTrunkPort