Reference Guide
704 Brocade Fabric OS Command Reference
53-1004112-02
portCfgNonDfe
Notes
This command is applicable only on an 8 Gbps 16 Gbps-capable port.
The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric
OS Commands" and "Command Availability" for details.
Operands This command has the following operands:
slot/
Specifies the slot number to be configured on bladed systems.
port[-port]
Specifies a port or a port range, relative to the slot number on bladed systems. This
command does not support multiple port ranges.
--enable
Enables non-DFE statically on the specified ports.
--disable
Disables non-DFE which allows automatic activation on the specified ports.
--show
Displays the non-DFE configuration and state on the specified ports.
--help
Displays the command usage.
Examples To enable non-DFE on a single port:
switch:admin> portcfgnondfe --enable 4/28
To enable non-DFE on a port range:
switch:admin> portcfgnondfe --enable 0-8
To enable the non-DFE feature on a range of ports (in this example, non-DFE is already enabled on ports 2 and 3):
switch:admin> portcfgnondfe --enable 2-4
Same configuration for port 2
Same configuration for port 3
To disable the non-DFE feature on a port range:
switch:admin> portcfgnondfe --disable 0-8
To display non-DFE configuration on a single port:
switch:admin> portcfgnondfe --show 7
Port: 7
8G Non-DFE Configured: OFF (Auto)
8G Non-DFE State: Active
switch:admin> portcfgnondfe --show 8
Port: 8
8G Non-DFE Configured: OFF (Auto)