Reference Guide

756 Brocade Fabric OS Command Reference
53-1004112-02
portCmd
-d | --dst dst_ip
Specifies the destination IP address to which to probe the IP router path. IPv6
addresses are supported.
-r | --rate rate
Specifies the test rate in kbps.
-t | --time time
Specifies the test time in seconds.
i | --ipsec-policy ip-sec_policy
Specifies the policy name for an ipsec configuration.
-b | --bi-directional
Specifies the test session is running on bi-directional traffic. By default, the WAN test
session is configured for uni-directional traffic.
-u | --uni-directional
Specifies the test session is running on uni-directional traffic.
--dscp dscp
Sets Differentiated Services Code Point (DSCP) markings for the WAN test session.
--l2cos l2cos
Sets the Layer 2 Class of Service (L2CoS) value for the WAN test session.
modify
Modifies an established WAN test session. This command supports following options:
-r rate
Specifies the test rate in kbps.
-t time
Specifies the test time in seconds.
-b
Specifies the test session is running on bi-directional traffic. By default, the WAN test
session is configured for uni-directional traffic.
-c
Clears the statistics associated with the WAN test.
show
Displays the WAN test session statistics. This command supports following options:
-summary
Displays statistics for active WAN test sessions.
--connection
Displays statistics for established WAN test sessions.
--detail
Displays detailed statistics for active WAN test sessions.
--historical
Displays statistics for past WAN test sessions.