Reference Guide

838 Brocade Fabric OS Command Reference
53-1004112-02
portShow
--link-local
Displays the link-local interface routes. This operand is optional.
arp
Displays the address resolution protocol (ARP) and IPv6 neighbor discovery table. You can
display the content of the ARP table, but you cannot modify its contents.
--link-local
Displays the neighbor discovery entries for the link-local addresses. This operand is
optional.
-lmac
Displays the local MAC address. This operand is optional.
vlantag
Displays the VLAN Tagging configuration. For each entry, the output displays the IP
interface address, the destination IP address, the VLAN ID, the L2 CoS priority, and a flag.
This display includes tunnel- and IPIF-level configurations. The following flags indicate the
type of configuration:
Perm
Permanent entry. Permanent entries are configured at the IP interface level with the portCfg
vlantag command.
Perm Net
Network-wide permanent entry. The same as the permanent entry except that no
destination address was defined (defaults to 0.0.0.0), so traffic to all destinations is tagged.
App
Application layer VLAN configuration defined at the circuit level.
autoneg
Displays the auto-negotiation status.
ipsec-policy
Displays IPSEC Policy information. Currently supported on Brocade 7840 switch only.
mgmtif
Displays the inband management interfaces configured for a specified GbE Port or for all
GbE Ports. For each GbE Port, the display includes the interface status (enabled or
disabled), the interface IPv4 Address, the netmask, effective MTU, and annotated port flags.
mgmtroute
Displays the management routes configured for a specified GbE Port or for all GbE Ports.
For each GbE Port, the display includes the destination IPv4 Address, the netmask, the
gateway address, and annotated port flags.
lag
Displays the static LAG information. For each entry, the output displays the LAG name,
state, port count, and member ports.
--detail
Displays a full view configuration details for all LAGs. The output displays the operational
state of LAG, port count, and the admin state, operational state, speed, and autonegotiation
status for the port members.