Service Manual

Fabric OS 7.4.0a Release Notes v2.0 Page 29 of 53
Obtaining the MIBs
You can download the MIB files required for this release from the downloads area of the MyBrocade site. To
download the Brocade-specific MIBs from the Brocade Technical Support website, you must have a user name
and password. Use the following steps to obtain the MIBs you want.
1. On your web browser, go to http://my.brocade.com.
2. Login with your user name and password.
3. Click the downloads tab.
4. On the downloads tab, under Product Downloads, select All Operating Systems from the Download by list.
5. Select Fabric Operating System (FOS), and then navigate to the release.
6. Navigate to the link for the MIBs package and either open the file or save it to disk.
NOTE:
NOTE:NOTE:
NOTE: Distribution of standard MIBs has been stopped. Download the required standard MIBs from the
http://www.oidview.com/ or http://www.mibdepot.com/ website.
Blade Support
DCX/DCX-4S Blade Support
Fabric OS v7.4 software is fully qualified and supports the blades for the DCX/DCX-4S noted in the following
table:
DCX/DCX-4S Blade Support Matrix
16-, 32-, 48- and 64-port 8Gbit port blades (FC8-
16, FC8-32, FC8-48, FC8-64)
Supported with FOS v6.0 and above (FC8-64 requires FOS v6.4)
with any mix and up to 8/4 of each. No restrictions around intermix.
FC10-6 Not supported on FOS v7.1 or later
Intelligent blade Up to a total of 8/4 intelligent blades. See below for maximum
supported limits of each blade.
Virtualization/Application Blade (FA4-18) Not supported on FOS v7.0 or later
FCIP/FC Router blade (FR4-18i) Not supported on FOS v7.1 or later
Encryption Blade (FS8-18) Up to a maximum of 4 blades of this type.
Extension Blade (FX8-24) Up to a maximum of 4 blades of this type.
FCoE/L2 CEE blade FCOE10-24 Up to a maximum of 4 blades of this type.
Not supported in the same chassis with other intelligent blades or
the FC8-64 port blade.
FC16-32, FC16-48, FC16-64, FC8-32E, FC8-48E Not supported
Table
Table Table
Table 1
11
1 Blade Support Matrix for DCX and DCX
Blade Support Matrix for DCX and DCXBlade Support Matrix for DCX and DCX
Blade Support Matrix for DCX and DCX-
--
-4
44
4S
SS
S with FOS v7.
with FOS v7.with FOS v7.
with FOS v7.4
44
4
Note:
Note:Note:
Note: The iSCSI FC4-16IP blade is not qualified for the DCX/DCX-4S.
DCX 8510-8/DCX 8510-4 Blade Support
Fabric OS v7.4 software is fully qualified and supports the blades for the DCX 8510-8 and DCX 8510-4 noted in
the table below.
DCX 8510-8/DCX 8510-4 Blade Support Matrix
FC16-32, FC16-48 16G FC blades FOS v7.0 or later.
FC16-64 blade
2,3
FOS v7.3 or later.