Users Guide

xxiv Fabric OS Command Reference
53-1002921-02
The following commands and associated man pages have been corrected or updated with
additional information:
• aaaConfig - The common secret can be between 1 to 40 characters long for the TACACS+
server.
• aliShow - Added the --ic operand to display the zone alias names without case distinction.
Added the help option.
• auditCfg - The class option 9 enables MAPS event auditing.
• bladeSwap - You cannot run this command if the source or destination blades are faulty.
• bottleneckMon - All credit recovery-related options supported by this command are also
available with the creditRecovMode command.
• cfgShow - Added the --ic operand to display all zone configuration names for a given pattern
without case distinction.
• cfgSize - The maximum supported zone database size for chassis-based switches has been
increased to 2 MB.
• chassisDistribute - The RPC port rules will be removed from the IP Filter policy database after
upgrading to Fabric OS v7.2.0.
• cliHistory - The maximum number of saved entries has been increased to 1680.
• configShow - Updated the command example.
• configure - Added the Dynamic D-Port, Location ID, and MAX num. of FLOGIs allowed options.
The edge hold time values are corrected.
• diagShow - You cannot interrupted this command by pressing the return key (<cr>).
• errDump - Corrected the typo in the --attribute operand name.
• fabricPrincipal - The -force option forces a fabric rebuild regardless of the principal mode of the
switch.
• fabricShow - Added the -paths operand to display the number of available paths to each
remote domain.
• fcrConfigure - Added new operands to specify the Backbone Fabric ID, to enable or disable the
shortest inter-fabric link (IFL) mode, and to display the configured setting.
• fcrEdgeShow - This command is enhanced to display ICL EX_Ports.
• ficonCfg - Updated the description of the port operand.
• ficonCupSet - Removed the unsupported FICON-CUP mode “UAM”.
• ficonCupShow - Added the reporting path state “primary” to the description of the LP operand.
• ficonHelp - Corrected the command example.
• ficonShow - The ILIR option is no longer used and the FICON ILIR database will always be
empty.
• firmwareDownload - Removed the unsupported option “-r”.
• help - Removed the deprecated command “agtcfgdefault” from the command example.
• ifModeSet - You can configure 1000 Mbps speed only when auto negotiation is on.
• interfaceShow - This command is enhanced to display the port substate.
• ipAddrSet - Added the --clear operand to clear the IPv4 and IPv6 addresses.
• ipFilter - Blocking or permitting the RPC ports 111, 897, and 898 using the -act operand is not
allowed.