Users Guide

Fabric OS Command Reference 335

53-1002921-02

fcrIclPathBWMonitor

Sets or displays FC Router ICL bandwidth monitor parameters for EX_Ports.

SYNOPSIS fcriclpathbwmonitor --enable

fcriclpathbwmonitor --disable

fcriclpathbwmonitor --show

fcriclpathbwmonitor --help

DESCRIPTION Use this command to enable or disable the Inter Chassis Link (ICL) EX_Ports bandwidth Monitor feature

on an FC Router, or to display the current status of ICL bandwidth feature and the ICL slot bandwidth

assigned to connected edge fabrics. If no operands are specified, this command displays the usage. By

default, this feature is disabled.

NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in

place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for

details.

OPERANDS This command has the following operands:

--enable

Enables the ICL EX_Port bandwidth Monitor feature on an FC Router. In the

enable mode, FC Router will periodically check for bandwidth imbalances from

each ICL slot of FC Router to each ICL slot of neighbor switch connected through

EX_Ports. A RASLog message will be generated when bandwidth imbalance is

detected or resolved to other fabric.

--disable

Disables the ICL EX_Port bandwidth Monitor feature on an FC Router.

--show

Displays the current ICL EX_Port bandwidth Monitor feature status and bandwidth

from each slot to connected edge fabric.

--help

Displays the command usage.

EXAMPLES To enable ICL EX_Port bandwidth Monitor:

fcr:admin> fcriclpathbwmonitor --enable

ICL bandwidth balance Monitor functionality is enabled

To disable ICL EX_Port bandwidth Monitor:

fcr:admin> fcriclpathbwmonitor --disable

ICL bandwidth balance Monitor functionality is disabled