Users Guide

632 Fabric OS Message Reference
53-1002929-01
MFIC-1001
5
MFIC Messages
MFIC-1001
Message failure at sysmod_scn registry rc= <failure reason>.
Message Type LOG
Severity ERROR
Probable Cause Indicates the system is temporarily out of resources.
Recommended
Action
No action is required; this message is often transitory.
If the message persists, run the reboot or the haFailover command (if applicable).
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
MFIC-1002
Message Chassis FRU header not programmed for switch NID, using defaults (applies only to
FICON environments).
Message Type LOG
Severity INFO
Probable Cause Indicates that custom switch node descriptor (NID) fields have not been programmed in nonvolatile
storage. The default values are used. The Switch NID is used only in the following SB ELS frames:
Request Node Identification Data (RNID) and Registered Link Incident Record (RLIR). The use of SB-3
link incident registration and reporting is typically limited to FICON environments.
Recommended
Action
No action is required if SB-3 link incident registration and reporting is not used by the host or if default
values are desired for the switch node descriptor fields.
MFIC-1003
Message Effective Insistent domain ID for the fabric changed from <state> to <state>.
Message Type LOG
Severity WARNING
Probable Cause Indicates that one or more switches joined the fabric with an insistent domain ID (IDID) mode setting that
is different from the current effective IDID mode for the fabric. This message also occurs when the IDID
for the fabric has been turned on or off. The possible values for the state are "On" and "Off".