Users Guide

772 Fabric OS Message Reference
53-1002929-01
SEC-1330
5
SEC-1330
Message <Name of command> command failed -<List of databases rejecting distribution> db(s)
are coming from a non-Primary switch.
Message Type LOG
Severity ERROR
Probable Cause Indicates an attempt was made to distribute databases either from a backup fabric configuration server
(FCS) switch or a non-FCS switch.
Recommended
Action
Verify the distribution is initiated by the FCS switch. Use the secPolicyShow command to verify and
correct the configuration if necessary.
SEC-1331
Message Attempt to enable secure mode failed. Reason: <Reason>.
Message Type LOG
Severity ERROR
Probable Cause Indicates the secModeEnable command failed on the fabric because default IP filter policies are not
active on the switch, or an active transaction exists on IP filter policies.
Recommended
Action
Verify the security event was planned.
If the security event was planned, run the ipfilter --activate default_ipv4 command or the ipfilter
--activate default_ipv6 command to activate default IP filter policies. Use the ipfilter --save or ipfilter
--transabort commands to save or abort the active transaction on IP filter policies. Then retry the
secModeEnable command.
SEC-1332
Message Fabric wide policy is conflicting as <Policy Name> is present in the fabric wide
policy and 5.3 or 5.2 switches present in the fabric.
Message Type LOG
Severity ERROR
Probable Cause Indicates the fabric-wide policy is conflicting.
Recommended
Action
Remove either the FCS from the fabric-wide policy, or remove Fabric OS v5.3 or Fabric OS v5.2 switches
from the fabric, or set the fabric-wide mode for FCS as strict.