Users Guide

864 Fabric OS Message Reference
53-1002929-01
SULB-1039
5
SULB-1039
Message CP has completed relocating the internal firmware image.
Message Type AUDIT | LOG
Class FIRMWARE
Severity INFO
Probable Cause Indicates that the firmware download process has completed normally on the control processor (CP).
Recommended
Action
Run the firmwareShow command to verify the firmware versions.
SULB-1040
Message An error has occurred during relocation of the internal image on the CP.
Message Type AUDIT | LOG
Class FIRMWARE
Severity WARNING
Probable Cause Indicates that an error has occurred during the relocation of the internal image. The error may be caused
by an inconsistent internal firmware image. It may also be caused by an internal Ethernet failure.
Recommended
Action
Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload
command again if the firmware is not updated.
This will cause the internal image to be relocated again. If the problem persists, contact your switch
service provider.
SULB-1041
Message Firmware has been activated successfully on standby CP.
Message Type AUDIT | LOG
Class FIRMWARE
Severity INFO
Probable Cause Indicates that the firmwareActivate command has completed successfully on the standby control
processor (CP).
Recommended
Action
No action is required. The firmwareActivate command has completed on the standby CP as expected.
Run the firmwareShow command to verify the firmware versions.