Messages Reference Guide

850 Fabric OS Message Reference

53-1002749-01

SWCH-1022

Message Port:<port number> has been disabled due to port address conflict while enabling

FMS mode.

Message Type LOG

Severity WARNING

Probable Cause Indicates that the switch has ports with FICON Management Server (FMS) reserved areas (0xFE, 0xFF)

that are not supported in FMS mode.

Recommended

Action

No action required. Refer to the FICON Administrator's Guide for more information.

SWCH-1023

Message HA state out of sync: Standby CP (ver = <standby SWC version>) does not support

XISL use while fmsmode and/or lossless are enabled (Active CP version =<active SWC

version>).

Message Type LOG

Severity WARNING

Probable Cause Indicates that the standby control processor (CP) does not support extended inter-switch link (XISL)

while FICON Management Server (FMS) mode and Lossless are enabled.

Recommended

Action

Load a firmware version on standby CP that supports both XISL use and FMS mode and Lossless at the

same time by using the firmwareDownload command.

SWCH-1024

Message HA state out of sync: Standby CP (ver = <standby SWC version>) does not support

active's enforce_login policy (Active CP version =<active SWC version>).

Message Type LOG

Severity WARNING

Probable Cause Indicates that the standby control processor (CP) does not enforce login policy of the active CP.

Recommended

Action

Configure the enforce login policy to a value that the standby CP supports.