Release Notes

Open Defects in Fabric OS v7.2.0
Fabric OS v7.2.0a Release Notes v1.0 Page 49 of 93
Defect ID:
DEFECT000450457
Technical Severity:
Medium
Summary:
ipfilter does not block access to port 80
Symptom:
When using ipfilter to block port 80, port 80 is still accessible. When connecting to the switch,
"Interface disabled" and "This Interface (x.x.x.x) has been disabled by the adminstrator." is presented
to the user.
Workaround:
As root, you could manually perform the following, but it will not be retained across reboots or
failovers,
iptables -L tcp0 <---used to verify rule position
iptables -D tcp0 2
iptables -L tcp0 <---used to verify rule position
iptables -D tcp0 2
Feature:
FOS Software
Function:
OS: Ethernet/Mgt Interface
Service Request ID:
1152370
Reported In Release:
FOS7.0.0
Probability:
High
Defect ID:
DEFECT000451364
Technical Severity:
Medium
Summary:
After switchdisable/enable of core switch, the edge fabric is flooded with [PS-5011] messages
Symptom:
After switchdisable/enable on the core switch, [PS-5011] messages are seen on the console
continuously.
Feature:
Performance Monitor
Function:
Top Talker
Reported In Release:
FOS7.2.0
Probability:
Low
Defect ID:
DEFECT000451699
Technical Severity:
Medium
Summary:
After disabling Static D-Port from the switch side, the device port comes up as a G-Port.
Symptom:
Device port comes up as a G-Port after disabling Static D-Port from the switch side
Workaround:
Removed static d-port configuration on HBA side or restart the D-Port test.
Feature:
Fabric Services
Function:
D-port
Reported In Release:
FOS7.2.0
Probability:
Low
Defect ID:
DEFECT000452546
Technical Severity:
Medium
Summary:
MAPS doesn’t count faulty blade as "FRU Health" Category in mapsdb
Symptom:
If MAPS starts monitoring after the blade is faulted, the faulty Blade is not being counted under "FRU
Health" Category in mapsdb
Feature:
Advanced Monitoring Services
Function:
Dashboard
Reported In Release:
FOS7.2.0
Probability:
Medium
Defect ID:
DEFECT000453088
Technical Severity:
Medium
Summary:
perfcleareemonitor will sometimes not clear upper 32 bits of ee monitor counter
Symptom:
perfcleareemonitor may occasionally not clear upper 32 bits of ee monitor counter.
Workaround:
run "perfcleareemonitor " again
Feature:
Performance Monitor
Function:
EE monitor
Reported In Release:
FOS7.2.0
Probability:
Medium
Defect ID:
DEFECT000454926
Technical Severity:
Medium
Summary:
Mixed 4G and 8G on the same asic cause 8G ISL reporting errors
Symptom:
On Brocade 300, observed CRC errors on 8G ISL ports when there are 4G ports in the same chip in a
specific customer configuration.
Feature:
8G ASIC Driver
Function:
ASIC Driver
Service Request ID:
1136914
Reported In Release:
FOS7.0.0
Probability:
Low