Users Guide

NOTE
Beginning at 5 on page 19, the steps are the same for both serial and Ethernet connections.
5. If you are setting up the switch for the first time, the addresses shown are not valid. If you click Next
with these addresses in place, EZSwitchSetup returns an error message.
To set up IPv4 addresses, edit the address information on the Set Switch IP Address window to
create static addresses appropriate for your LAN connection.
To set up IPv6 addresses, enter the IPv6 address and prefix in the spaces provided.
6. Click Next.
EZSwitchSetup attempts to log in using default credentials. If you have already changed your
admin password, you will be prompted to enter your new password.
Proceed to
Confirming IP addresses on page 19.
Confirming IP addresses
The Confirm IP Address window (
FIGURE 10 on page 19) is displayed after you have assigned IP
addresses, using either a serial connection or an Ethernet connection.
FIGURE 10 Confirm IP Address window
Setting Up Your Switch
EZSwitchSetup Administrator’s Guide 19
53-1002940-01