Deployment Guide
Distributing an SCC, DCC, or FCS policy
Perform this procedure to distribute an SCC, DCC, or FCS policy.
NOTE
SCC and DCC policy can be distributed only for a primary switch.
To distribute an SCC, DCC, or FCS policy, perform the following steps.
1. Open the Switch Administration window as described in Opening the Switch Administration window
on page 52.
2. Select the Security Policies tab.
3. Select the appropriate tab (SCC, DCC, or FCS).
4. Click Distribute Policy.
5. Select the switches that will receive the policy.
6. Select OK.
If the policy distribution fails, an error dialog box displays.
Moving an FCS policy switch position
You can move the position of a primary switch in the FCS policy list.
To move an FCS policy switch position, perform the following steps.
1. Open the Switch Administration window as described in Opening the Switch Administration window
on page 52.
2. Click Show Advanced Mode.
3. Select the Security Policies tab.
4. Select the FCS tab.
5. Click Move FCS Switch.
6. Select the appropriate from and to positions.
7. Click Apply.
8. After you move all the member switches, click Apply and Close.
Configuring Advanced Device Security policy
The ADS policy allows you to restrict devices that are logged into the fabric using a particular F_Port.
When this policy is enabled only authorized devices are allowed to log in the fabric. This can be
achieved by allowing all the devices, blocking all the devices, or giving access to selected devices. ADS
is supported only in Access Gateway mode.
The restrictions to device login are:
• All Access --Allows all the devices to log in to the fabric through that F_Port.
• No Access --Blocks all the devices trying to log in to the fabric through that F_Port.
• WWNs --Allows only selected WWNs to log in to the fabric through that F_Port. NPIV-capable device
port WWNs can also be added to the allowed list of device port WWNs for the particular F_Port.
When the ADS policy is enabled the first time, all the F_Ports are set to All Access and all the devices
are allowed to log in to the fabric. This configuration persists for subsequent logins from all devices.
Existing devices that are already logged in to the fabric are not affected.
Distributing an SCC, DCC, or FCS policy
Web Tools Administrator's Guide 211
53-1003169-01