Users Guide

154 Fabric OS Message Reference
53-1002929-01
AUTH-1018
5
AUTH-1018
Message Invalid value to check protocol type: port <port number>.
Message Type LOG
Severity ERROR
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1020
Message Failed to create timer for authentication: port <port number>.
Message Type LOG
Severity INFO
Probable Cause Indicates that an authentication message timer was not created. Usually this problem is transient. The
authentication may fail.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1022
Message Failed to extract <data type> from <message> payload: port <port number>.
Message Type LOG
Severity ERROR
Probable Cause Indicates the authentication process failed to extract a particular value from the receiving payload.
Usually this problem is transient. The authentication may fail.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.