Users Guide

866 Fabric OS Message Reference
53-1002929-01
SULB-1050
5
SULB-1050
Message Firmwaredownload command continues.
Message Type AUDIT | LOG
Class FIRMWARE
Severity INFO
Probable Cause Indicates that the firmwareDownload command is running on the standby control processor (CP) of the
dual-CP system. This process should take approximately 17 minutes. The process is set to time out after
30 minutes.
Recommended
Action
Do not fail over or power down the system during firmware upgrade. Allow the firmwareDownload
command to continue without disruption. No action is required.
Run the firmwareDownloadStatus command for more information.