Administrator's Guide

Access Gateway Administrator’s Guide xv
53-1002743-01
• Chapter 2
- Added port mapping details for the Brocade 5430 switch to “Access Gateway default port
mapping” on page 17. Table 5,
- Added “D_Port support” on page 32.
• Chapter 3
- Added notes to “Failover policy” on page 50 and “Failback policy” on page 55 that If
failover and failback policy are disabled, an F_Port mapped to an N_Port will go offline
when the N_Port goes offline and it will go online when the N_Port comes online.
- Under“Considerations for the Brocade 6505 and 6510” on page 72, added that all ports
on demand (POD) licenses must be present to support Access Gateway.
For further information, refer to the release notes.
Document conventions
This section describes text formatting conventions and important notices formats.
Text formatting
The narrative-text formatting conventions that are used in this document are as follows:
bold text Identifies command names
Identifies the names of user-manipulated GUI elements
Identifies keywords and operands
Identifies text to enter at the GUI or CLI
italic text Provides emphasis
Identifies variables
Identifies paths and Internet addresses
Identifies document titles
code text Identifies CLI output
Identifies syntax examples
For readability, command names in the narrative portions of this guide are presented in mixed
lettercase: for example, switchShow. In actual examples, command lettercase is often all
lowercase.
Command syntax conventions
Command syntax in this manual follows these conventions:
command Commands are printed in bold.
--option, option Command options are printed in bold.
-argument, arg Arguments.
[ ] Optional element.