Deployment Guide

Fabric OS Message Reference 789
53-1003140-01
SEC-1166
5
Recommended
Action
Wait a few minutes and try the command again.
SEC-1166
Message Non FCS tries to commit failover.
Message Type LOG
Severity ERROR
Probable Cause Indicates a corruption occurred during the distribution of the security database. This can only occur when
the primary fabric configuration server (FCS) distributes the security database to the other switches in
the fabric, and then local validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.
SEC-1167
Message Another FCS failover is in process. Command terminated.
Message Type LOG
Severity ERROR
Probable Cause Indicates that because another failover is already in progress, this failover attempt cannot proceed.
Recommended
Action
Verify the security event was planned. If the security event was planned, retry fabric configuration server
(FCS) failover after the current failover has completed, if this switch should become the primary FCS. If
the security event was not planned, take appropriate action as defined by your enterprise security policy.
SEC-1168
Message Primary FCS failover is busy. Please retry later.
Message Type LOG
Severity ERROR
Probable Cause Indicates a corruption occurred during the distribution of the security database. This can only occur when
the primary fabric configuration server (FCS) distributes the security database to the other switches in
the fabric, and then local validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.