Deployment Guide

808 Fabric OS Message Reference
53-1003140-01
SEC-1321
5
SEC-1321
Message Failed secure mode enable command. Reason: <Reason>.
Message Type LOG
Severity ERROR
Probable Cause Indicates the security enable failed on the fabric because the switch has a conflicting configuration such
as fabric-wide consistency configuration or AD configuration.
Recommended
Action
Verify the security event was planned. If the security event was planned, run the fddCfg --fabwideset
command or ad --clear command to clear the fabric wide consistency configuration or AD configuration
and retry the secModeEnable command.
SEC-1322
Message Some DCC policy is too large, distribution cancelled.
Message Type LOG
Severity WARNING
Probable Cause Indicates this fabric is not able to support a Device Connection Control (DCC) policy with more than 256
ports.
Recommended
Action
Reconfigure any policy that includes more than 256 ports in its member list, and then save the policy
configuration changes.
SEC-1323
Message Key(s) \"<Key Name>\" ignored during configdownload.
Message Type LOG
Severity INFO
Probable Cause Indicates the specified key is ignored during configuration download.
Recommended
Action
Verify the event was planned. If the event was planned, no action is required. If the event was not
planned, take appropriate action as defined by your enterprise security policy.