Release Notes

Open Defects in Fabric OS v7.2.0
Fabric OS v7.2.0a Release Notes v1.0 Page 40 of 93
Defect ID:
DEFECT000423640
Technical Severity:
High
Summary:
Upgrade a flash card driver version.
Symptom:
On rare occasions excessive writing to an old flash card could cause it no longer be accessible during
switch bootup.
Feature:
Embedded Platform Services
Function:
Other
Service Request ID:
,1162762
Reported In Release:
FOS6.4.3_dcb
Probability:
Low
Defect ID:
DEFECT000425974
Technical Severity:
High
Summary:
Fabric Watch reports all zeros for 16G SFPs.
Symptom:
Observe invalid Fabric Watch messages for 16G SFPs.
Feature:
FOS Software
Function:
Management Services
Service Request ID:
1095374
Reported In Release:
FOS7.0.0
Probability:
Low
Defect ID:
DEFECT000426301
Technical Severity:
High
Summary:
Inherited FID is retained even if the VF enabled switch moved out of the fabric.
Symptom:
Merging a new VF enabled switch(with different FID) to an existing VF disabled fabric fails with E
port segment reason of “FID conflict”
Feature:
FOS Software
Function:
Virtual Fabric
Service Request ID:
1101582 -- 1101547
Reported In Release:
FOS6.4.1
Probability:
Low
Defect ID:
DEFECT000429970
Technical Severity:
High
Summary:
Host LUN discovery between two edges fails in FCR routed fabric
Symptom:
A host in an edge fabric that is zoned with a target in another edge can not discover the LUNs across
the routed fabric when the host is removed and then subsequently added back to the LSAN zone.
Feature:
8G FCR
Function:
Other
Reported In Release:
FOS7.1.0
Probability:
Medium
Defect ID:
DEFECT000430219
Technical Severity:
High
Summary:
Ports in a Condor3-Condor2 ISL may be fenced unexpectedly after portenable when FabricWatch is
enabled with LR high threshold level set to custom values significantly below the default
Symptom:
Ports are fenced unexpectedly
Workaround:
Increase the FabricWatch LR threshold
Feature:
FABRIC WATCH
Function:
PORT FENCING
Reported In Release:
FOS7.1.0
Probability:
Medium
Defect ID:
DEFECT000431369
Technical Severity:
High
Summary:
Brocade switch mib browser displays incorrect/misinterperated fcportflag
Symptom:
Mib browser displays ascii-hex of populated fcportflag value. For example it displays "30" for 0, "31"
for 1, where expected display is "0", "1".
Feature:
FOS Software
Function:
SNMP
Service Request ID:
1106614
Reported In Release:
FOS7.0.2
Probability:
Medium