Install Guide

System and Security Properties 33
RSA BSAFE SSL-J 6.2.6 Installation Guide
3. Right click com.rsa.bsafe.android.variant.TestMainActivity
where variant is one of:
–
sslj
– sslj.fips
– ssljnative
– ssljnative.fips
4. From the drop-down box, select Run.
To run the system tests on the attached device:
1. On the attached device, select Start from the menu list to run the tests.
To collect the test results in an HTML report:
1. In the development environment, run the following Gradle task:
pullvariantTestReport
where variant is one of:
–
sslj
– ssljFips
– ssljNative
– ssljNativeFips
2. View root/sslj-src/android/BsafeAndroid/build/reports to
locate the reports for each test.
System and Security Properties
System and security properties in SSL-J are used to statically register the JCE provider
and to configure the toolkit and FIPS-140 mode behavior.
For further detail, see the Welcome to the SSL-J Toolkit > Introduction To SSL-J >
System and Security Properties section of the RSA BSAFE SSL-J Developers Guide.
Uninstallation Instructions
To un-install SSL-J on all platforms, remove all files and directories created during the
installation process.