Setup Guide

Figure 9. C1048P Port Numbering
1. C1048P 10/100/1000BASE-T ports 1-48
Next Steps
After you complete the initial C1048P provisioning, you can configure L2 software features on the
C1048P from the C9010 console CLI, including LLDP, 802.1x, LACP, loop detection and BPDU guard. No
other L2 protocols are supported. IP address and L3 protocol configuration on C1048P ports are not
supported. For detailed information, see the
Dell Networking Configuration Guide for C9000 Series
Switches.
When the C1048P is online, you can enter the connect pe pe-id command on the C9010 console to
remotely log in to the C1048P CLI. To log in, enter the user name
peadmin and the password calvin.
After logging in, you can enter show and stack renumbering commands on the C1048P.
To move through command modes in the C1048P CLI, see the Command Modes section in the Dell
Networking C9010 Getting Started Guide.
22
Configuring the Software