User’s Guide
Table Of Contents
- Safety Instructions
- About Your Monitor
- Setting Up the Monitor
- Setting Up the Stand
- Operating the Monitor Webcam
- Organizing Your Cables
- Securing Your Monitor Using Kensington Lock (optional)
- Connecting Your Monitor
- Using the Tilt, Swivel, and Vertical Extension
- Rotating the Monitor
- Adjusting the Rotation Display Settings of Your System
- Removing the Monitor Stand
- VESA Wall Mounting (optional)
- Operating the Monitor
- Troubleshooting
- Appendix
40 │ Setting Up the Monitor
Connecting the HDMI Cable
NOTE: The default out of factory setting is HDMI 1.4.
Connecting the DisplayPort (DisplayPort to DisplayPort) Cable
NOTE: The default out of factory setting is DP1.2. If the monitor fails to
show any content after the DisplayPort cable is connected, follow the
procedures below to change the settings to DP1.1:
• Press the joystick to open the Menu Launcher.
• Toggle the joystick to select Input Source.
• Toggle the joystick to highlight DP.
• Press and hold the joystick for approximately 10 seconds, and the DisplayPort
con
figuration message appears.
• Toggle the joystick to select Ye
s and then press the joystick to save the
changes.