User’s Guide
Table Of Contents
- Safety Instructions
- About Your Monitor
- Setting Up the Monitor
- Setting Up the Stand
- Operating the Monitor Webcam
- Organizing Your Cables
- Securing Your Monitor Using Kensington Lock (optional)
- Connecting Your Monitor
- Using the Tilt, Swivel, and Vertical Extension
- Rotating the Monitor
- Adjusting the Rotation Display Settings of Your System
- Removing the Monitor Stand
- VESA Wall Mounting (optional)
- Operating the Monitor
- Troubleshooting
- Appendix
66 │ Operating the Monitor
The OSD functions only in the normal operation mode. If you press any button other
than the Power Button during the Standby mode, the following message will
appear depending on the selected input:
NOTE: The message may be slightly different according to the
connected input signal.
Activate the computer and the monitor to gain
access to the OSD.
NOTE: The message may be slightly different according to the
connected input signal.
If either DisplayPort or HDMI input is selected and the corresponding cable is not
co
nnected, a dialog box as shown below appears.
or
NOTE: The message may be slightly different according to the
connected input signal.