Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge T150 Installation and Service Manual
- Contents
- About this document
- PowerEdge T150 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Frontbezel
- Drives
- Removing a 3.5-inch drive carrier from the drive bay
- Installing a 3.5-inch drive carrier into the drive bay
- Removing a drive from the drive carrier
- Installing a drive into the drive carrier
- Removing a 2.5-inch drive from the 3.5-inch drive adapter
- Installing a 2.5-inch drive into the 3.5-inch drive adapter
- Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
- Installing a 3.5-inch adapter into a 3.5-inch drive carrier
- Setting the cooling fan speed for 8 TB drives
- Cable routing
- Optional optical drive
- System memory
- Cooling fans
- Internal USB memory key
- Expansion cards
- Optional BOSS S1 card
- Processor and heat sink
- Power supply unit
- System battery
- Intrusion switch
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
2. Select iDRAC setting.
3. Select Thermal section.
4. Select Fan Setup setting.
5. At the Fan Speed Offset section, select Low fan speed offset (+15%).
Cable routing
Figure 20. Cable routing - 4 x 3.5-inch cabled SATA drive
Table 10. Connector descriptions for 4 x 3.5-inch cabled SATA drive
From To
ODD (Optical disc drive connector) SATA_ODD (Optical disc drive SATA connector on system
board)
ODD_PWR + HDD0, HDD1, HDD2, HDD3 (Optical disc drive
power connector, connecting through the drives 0, 1, 2, 3)
HDD/ODD_PWR (Drives/Optical disc drive power connector
on the system board)
HDD0, HDD1, HDD2, HDD3 (Signal connector connecting
through the drives 0, 1, 2, 3)
SL1_PCH_SA1 (Signal connector on system board, cable
marking MB SL1)
34 Installing and removing system components