Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge T150 Installation and Service Manual
- Contents
- About this document
- PowerEdge T150 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Frontbezel
- Drives
- Removing a 3.5-inch drive carrier from the drive bay
- Installing a 3.5-inch drive carrier into the drive bay
- Removing a drive from the drive carrier
- Installing a drive into the drive carrier
- Removing a 2.5-inch drive from the 3.5-inch drive adapter
- Installing a 2.5-inch drive into the 3.5-inch drive adapter
- Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
- Installing a 3.5-inch adapter into a 3.5-inch drive carrier
- Setting the cooling fan speed for 8 TB drives
- Cable routing
- Optional optical drive
- System memory
- Cooling fans
- Internal USB memory key
- Expansion cards
- Optional BOSS S1 card
- Processor and heat sink
- Power supply unit
- System battery
- Intrusion switch
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 21. Cable routing - 4 x 3.5-inch cabled SAS drive with storage controller card
Table 11. Connector descriptions for 4 x3.5-inch cabled SAS drive with storage controller card
From To
ODD (Optical disc drive connector) SATA_ODD (Optical disc drive SATA connector on system
board)
ODD_PWR + HDD0, HDD1, HDD2, HDD3 (Optical disc drive
power connector, connecting through the drives 0, 1, 2, 3)
HDD/ODD_PWR (Drives/Optical disc drive power connector
on the system board)
HDD0, HDD1, HDD2, HDD3 (Signal connector connecting
through the drives 0, 1, 2, 3)
PERC (SAS connector of PERC card on the system board)
Optional optical drive
This is a service technician replaceable part only.
Removing the optical drive fillers
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system.
3. Remove the front bezel.
NOTE: There are two optical drive fillers, plastic filler on the front bezel, and metal filler on the optical drive cage.
Steps
1. On the front bezel, press the retention clip of the optical drive filler and pull the filler from the front bezel.
Installing and removing system components
35