Service Manual

Steps
1. Place the hard-drive into the bracket.
2. Align and insert the pins on the drive bracket with the slots on the drive.
NOTE: Note the orientation of the hard-drive so that you can replace it correctly.
Next steps
1. Install the hard-drive assembly.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Installing the hard-drive assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the hard-drive assembly and provides a visual representation of the installation
procedure.
22
Removing and installing components