Service Manual
Table Of Contents
- OptiPlex 3000 Micro Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Connect the fan cable to the connector on the system board.
2. Turn the fan assembly over.
3. Press the release tab on the fan assembly and place it on the system until it clicks into place.
Next steps
1. Install the speaker.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Heat sink
NOTE: This section applies to 35 W and 65 W configuration systems.
Removing and installing components 29