Service Manual
Table Of Contents
- Latitude 3520 Service Manual
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- MicroSD-card
- SIM card tray
- Base cover
- Battery cable
- Battery
- Memory module
- M.2 solid-state drive thermal plate
- M.2 solid-state drive conversion bracket
- M.2 solid-state drive
- Hard-disk drive
- WLAN card
- WWAN card
- I/O cable
- Display assembly
- System fan
- Heatsink assembly
- Power adapter port
- Coin-cell battery
- USB cable
- Ethernet port
- I/O board
- Power-button board
- System board
- Speakers
- Touchpad
- WWAN I/O board
- Palmrest assembly
- Display bezel
- Display panel
- Camera
- Display cable
- Display back-cover
- Drivers and downloads
- System setup
- Troubleshooting
- Built-in self-test (BIST)
- LCD Built-in Self Test (BIST)
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Diagnostic LED behavior
- Diagnostic error messages
- System error messages
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Flashing the BIOS
- Backup media and recovery options
- WiFi power cycle
- Flea power release
- Getting help and contacting Dell
2. Slide the solid-state drive into the solid-state drive slot on the system board.
3. Replace the (M2x3) screw to secure the solid-state drive to the system board.
Next steps
1. Install the base cover.
2. Exit the service mode
3. Install the SIM card tray for 4G LTE enabled systems.
4. Install the microSD-card.
5. Follow the procedure in after working inside your computer.
Removing the M.2 2280 solid-state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
3. Remove the SIM card tray for 4G LTE enabled systems.
4. Enter the service mode.
5. Remove the base cover.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
Steps
1. Remove the (M2x3) screw that secures the solid-state drive to the system board.
2. Slide and remove the solid-state drive from the solid-state drive slot on the system board.
Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
34
Removing and installing components