Personal Computer User Manual

134 Installing System Components
Installing a Sled
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Orient the sled so that the release latch is in the bottom of the sled.
See Figure 3-4.
2 Slide the new sled into the enclosure until the sled is fully seated and the
release latch snaps into place. See Figure 3-4.
Sled Blank
CAUTION: To ensure proper airflow in the system, if a module is removed it
should be immediately replaced with another sled or sled blank.
The information in this section include replacement procedures for the
single-side and double-wide sled blank.
Removing a Single-Wide Sled Blank
1 Pull up on the sled blank latch at the bottom of the sled to disengage the
sled from the server enclosure. See Figure 3-5.
2 Using the handle, slide the sled out of the enclosure. See Figure 3-5.
1 release latch 2 handle