Users Guide

TX MULTICAST ENTRY 0 0
0
TX INTER SPINE ENTRY 0 0
0
DROP ENTRY 0 0
0
CP bound IPC 847344 847344
0
RP bound IPC 9180 9180
0
ECP bound IPC 34484 34484
0
SFLOW_EGRESS 0 0
0
SFLOW_INGRESS 0 0 0
To clear the per-protocol counters of rate-limited control-plane traffic at the aggregated (switch) or line
card and port set level, use the clear control-traffic protocol [cp—switch | linecard {0–
2} portset {0–3}] counters
command; for example:
Dell#clear control-traffic protocol linecard 1 portset 2 counters
Dell#
Dell#clear control-traffic protocol cp-switch counters
Dell#
Viewing Per-Queue CoPP Counters
To view per-queue counters of CoPP rate-limited traffic, use the show control-traffic queue
{all | queue-id queue-number} counters command.
The range of queue-number values is from 0 to 20. The twenty-one control–plane queues are divided
into groups of seven queues for the Route Processor, Control Processor, and line-card CPUs as follows:
• Queues 0 to 6 process packets destined to the Control Processor CPU .
• Queues 7 to 13 process packets destined to the Route Processor CPU.
• Queues 14 to 20 process packets destined to the line card CPU.
In the show output, Rx Counters displays the number of bytes of control-plane traffic received, on which
queue-based rate limiting is applied. Tx Counters displays the number of bytes transmitted to a control-
plane CPU after queue-based rate limiting is applied. Drop Counters displays the number of bytes of
control-plane traffic that have been dropped as a result of queue-based rate limiting.
Dell#show control-traffic queue queue-id 6 counters
Queue-ID RxBytes TxBytes Drops
-------- -------- ------- -----
Q6 24016 24016 0
Dell#show control-traffic queue all counters |no-more
Queue-ID RxBytes TxBytes Drops
-------- -------- ------- -----
Q0 0 0 0
Q1 0 0 0
Q2 0 0 0
Q3 0 0 0
Q4 0 0 0
Q5 0 0 0
Q6 21673 21673 0
Q7 0 0 0
Q8 0 0 0
Q9 0 0 0
270
Control Plane Policing (CoPP)