Users Guide

show hg-link-bundle—distribution {cp | linecard slot—id} npuUnit unit-number
hg-port-channel channel-num
Troubleshoot a flap or fault condition on a HiGig backplane link by displaying the internal ports that
are mapped to backplane links for control or data traffic and the status of backplane links. In the show
hardware bp-link-state command output, 1 indicates that a backplane link is up; 0 indicates the
a link is down. You can also display the traffic utilization of member interfaces in a HiGig port channel
that transmits control or data traffic from the Control Processor or a line card over the C9000 series
backplane.
unit defines the Network Processing unit (NPU) of a HiGig port channel. hg-port-
channel defines the HiGig port-channel number.
NOTE:
In the C9000 series CLI, NPUs are sometimes referred to as units.
Besides the front-end I/O ports on line cards, the C9000 series uses six internal SFM units to
transmit the data between line-card ports.
Environmental Monitoring
The system components use environmental monitoring hardware to detect transmit power readings,
receive power readings, and temperature updates.
To receive periodic power updates, enable the enable optic-info-update interval command.
The output in the following example displays the environment status of the RPM.
Example of the show interfaces transceiver Command
Dell#show interfaces tengigabitethernet 10/1 transceiver
SFP is present
SFP+ 1 Serial Base ID fields
SFP+ 1 Id = 0x03
SFP+ 1 Ext Id = 0x04
SFP+ 1 Connector = 0x21
SFP+ 1 Transceiver Code = 0x00 0x00 0x00 0x00 0x00 0x04 0x00 0x00
SFP+ 1 Encoding = 0x00
SFP+ 1 BR Nominal = 0x67
SFP+ 1 Length(SFM) Km = 0x00
SFP+ 1 Length(OM3) 2m = 0x00
SFP+ 1 Length(OM2) 1m = 0x00
SFP+ 1 Length(OM1) 1m = 0x00
SFP+ 1 Length(Copper) 1m = 0x01
SFP+ 1 Vendor Rev = A
SFP+ 1 Laser Wavelength = 256 nm
SFP+ 1 CheckCodeBase = 0xf3
SFP+ 1 Serial Extended ID fields
SFP+ 1 Options = 0x00 0x00
SFP+ 1 BR max = 0
SFP+ 1 BR min = 0
SFP+ 1 Vendor SN = APF11370028AH5
SFP+ 1 Datecode = 110917
SFP+ 1 CheckCodeExt = 0xde
SFP+ 1 DOM is not supported
Debugging and Diagnostics
353