Users Guide

Password to login remote host:

Example of Copying to NFS Mount

Dell#copy flash://test.txt nfsmount://

Destination file name [test.txt]:

15 bytes successfully copied

Dell#copy flash://ashu/capture.txt.pcap nfsmount://

Destination file name [test.txt]:

15 bytes successfully copied

Dell#copy flash://ashu/capture.txt.pcap nfsmount://

username/snoop.pcap

24 bytes successfully copied

Dell#

Dell#copy tftp://10.16.127.35/

username/dv-maa-C9010-test ?

flash: Copy to local file system ([flash://]filepath)

nfsmount: Copy to nfs mount file system (nfsmount://filepath)

running-config remote host:

Destination file name [test.c]:

225 bytes successfully copied

Dell#

Default Configuration

Although a version of the Dell Networking OS is pre-loaded on the switch, the system is not configured

when you power up the first time (except for the default hostname, which is Dell). You must configure

the system using the CLI.

Configuring a Host Name

The host name appears in the prompt. The default host name is Dell.

• Host names must start with a letter and end with a letter or digit.

• Characters within the string can be letters, digits, and hyphens.

To create a host name, use the following command.

• Create a host name.

CONFIGURATION mode

hostname name

Example of the hostname Command

Dell(conf)#hostname R1

R1(conf)#

Accessing the System Remotely

You can configure the system to access it remotely by Telnet or SSH.

• The switch has a dedicated management port and a management routing table that is separate from

the IP routing table.

Getting Started