Users Guide

Feature and Functionality Dell Networking OS Release
Introduction
Documentation and Chapter
Location
IPv6 IS-IS in the Dell Networking
OS Command Line Reference
Guide.
OSPF for IPv6 (OSPFv3) 8.3.11 OSPFv3 in the Dell Networking OS
Command Line Reference Guide.
Equal Cost Multipath for IPv6 8.3.11
IPv6 Services and Management
Telnet client over IPv6
(outbound Telnet)
8.3.11 Configuring Telnet with IPv6
Control and Monitoring in the Dell
Networking OS Command Line
Reference Guide.
Telnet server over IPv6 (inbound
Telnet)
8.3.11 Configuring Telnet with IPv6
Control and Monitoring in the Dell
Networking OS Command Line
Reference Guide.
Secure Shell (SSH) client support
over IPv6 (outbound SSH) Layer
3 only
8.3.11 Secure Shell (SSH) Over an IPv6
Transport
Secure Shell (SSH) server support
over IPv6 (inbound SSH) Layer 3
only
8.3.11 Secure Shell (SSH) Over an IPv6
Transport
IPv6 Access Control Lists 8.3.11 IPv6 Access Control Lists in the
Dell Networking OS Command
Line Reference Guide.
IPv6 Multicast
MLDv1/v2 N/A
IPv6 PIM in the Dell Networking
OS Command Line Reference
Guide.
Configuring the LPM Table for IPv6 Extended Prefixes
The LPM CAM table consists of two partitions: Partition I for IPv6 /65-/128 route-prefix entries and
Partition II for IPv6 0/0-/64 and IPv4 0/0-0/32 route-prefix entries. You must reconfigure LPM CAM to
allow IPv6 /65-/128 route prefixes to be stored in Partition I.
• Use the cam-ipv6 extended-prefix command to enable IPv6 /65-/128 route prefixes to be stored
in LPM CAM Partition 1. You must specify the maximum number of IPv6 prefixes with /65-/128 mask
length that are supported in the partition. The valid values are 1024, 2048 or 3072 prefixes. You must
save the configuration and reload the switch for the change to take effect.
• The number of entries in Partition II is reduced as the number of entries in Partition I increases.
• To disable LPM CAM partitioning and return the number of the IPv6 /65-/128 route prefixes stored in
Partition 1 to 0, enter the no cam-ipv6 extended-prefix command.
528
IPv6 Routing