Users Guide

To validate the software image on the flash drive after the image has been transferred to the system, but

before the image has been installed, use the verify {md5 | sha256} [ flash://]img-file [hash-value]

command in EXEC mode.

• md5: MD5 message-digest algorithm

• sha256: SHA256 Secure Hash Algorithm

• flash: (Optional) Specifies the flash drive. The default is to use the flash drive. You can just enter the

image file name.

• hash-value: (Optional). Specify the relevant hash published on i-Support.

• img-file: Enter the name of the Dell Networking software image file to validate

Examples: Without Entering the Hash Value for Verification

MD5

Dell# verify md5 flash://FTOS-SE-9.5.0.0.bin

MD5 hash for FTOS-SE-9.5.0.0.bin: 275ceb73a4f3118e1d6bcf7d75753459

SHA256

Dell# verify sha256 flash://FTOS-SE-9.5.0.0.bin

SHA256 hash for FTOS-SE-9.5.0.0.bin:

e6328c06faf814e6899ceead219afbf9360e986d692988023b749e6b2093e933

Examples: Entering the Hash Value for Verification

MD5

Dell# verify md5 flash://FTOS-SE-9.5.0.0.bin 275ceb73a4f3118e1d6bcf7d75753459

MD5 hash VERIFIED for FTOS-SE-9.5.0.0.bin

SHA256

Dell# verify sha256 flash://FTOS-SE-9.5.0.0.bin

e6328c06faf814e6899ceead219afbf9360e986d692988023b749e6b2093e933

SHA256 hash VERIFIED for FTOS-SE-9.5.0.0.bin

Verifying System Images on C9010 Components

Each C9010 RPM contains three components: Control Processor (CP), Route Processor (RP), and line-

card processor (LP). Each RPM component has a separate system image stored in the A: and B: flash

partitions. In addition, each installed C9010 line card has a separate image stored in partitions A: and B:.

To display the system images currently stored for all C9010 components, enter the show boot system

all

command. In the command output:

• Column A: lists the system images stored in flash partition A: for each RPM component. Column B:

lists the system images stored in partition B:.

• The components of RPM0 installed in chassis slot 10 are:

– RPM0 control processor: rmp 0 (CP)

– RPM0 route processor: rmp 0 (RP)

– RPM0 line-card processor: linecard 10

• The components of RPM1 installed in chassis slot 11 are:

Switch Management