Users Guide

Important Points to Remember
• The Dell Networking OS implementation of the sFlow MIB supports sFlow configuration via snmpset.
• Dell Networking recommends the sFlow Collector be connected to the Dell Networking chassis
through a line card port rather than the management Ethernet port.
• Only egress sampling is supported.
• The system exports all sFlow packets to the collector. A small sampling rate can equate to many
exported packets. A backoff mechanism is automatically applied to reduce this amount. Some
sampled packets may be dropped when the exported packet rate is high and the backoff mechanism
is about to or is starting to take effect. The dropEvent counter, in the sFlow packet, is always zero.
• Community list and local preference fields are not filled in extended gateway element in the sFlow
datagram.
• 802.1P source priority field is not filled in extended switch element in sFlow datagram.
• Only Destination and Destination Peer AS number are packed in the dst-as-path field in extended
gateway element.
• If the packet being sampled is redirected using policy-based routing (PBR), the sFlow datagram may
contain incorrect extended gateway/router information.
• The source virtual local area network (VLAN) field in the extended switch element is not packed in
case of routed packet.
• The destination VLAN field in the extended switch element is not packed in a Multicast packet.
Enabling and Disabling sFlow
By default, sFlow is disabled globally on the system.
Use the following command to enable sFlow globally.
• Enable sFlow globally.
CONFIGURATION mode
[no] sflow enable
Enabling and Disabling sFlow on an Interface
By default, sFlow is disabled on all interfaces.
This CLI is supported on physical ports and link aggregation group (LAG) ports.
To enable sFlow on a specific interface, use the following command.
• Enable sFlow on an interface.
INTERFACE mode
[no] sflow enable
To disable sFlow on an interface, use the no version of this command.
sFlow Show Commands
You can display sFlow statistics at the switch, interface, and line card level.
• Displaying Show sFlow Globally
sFlow
957