Administrator Guide

The following is an example of single range on PE ports.
Dell(config)#interface range peGigE 1/0/4-47
Dell(conf-if-range-pegi-1/0/4-47)# no shut
Dell(conf-if-range-pegi-1/0/4-47)#
Create a Multiple-Range
The following is an example of multiple range.
Dell(conf)#interface range tengigabitethernet 0/5 - 10 , tengigabitethernet 0/1 , vlan 1
Dell(conf-if-range-te-0/5-10,te-0/1,vl-1)#
Exclude Duplicate Entries
The following is an example showing how duplicate entries are omitted from the interface-range prompt.
Dell(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3
Dell(conf-if-range-vl-1,vl-3)#
Dell(conf)#interface range tengigabitethernet 2/0 - 23 , tengigabitethernet 2/0 - 23 ,
tengigabitethernet 2/0 - 23
Dell(conf-if-range-te-2/0-23)#
Exclude a Smaller Port Range
The following is an example show how the smaller of two port ranges are omitted in the interface-range prompt.
Dell(conf)#interface range tengigabitethernet 2/0 - 23 , tengigabitethernet 2/1 - 10
Dell(conf-if-range-te-2/0-23)#
Overlap Port Ranges
The following is an example showing how the interface-range prompt extends a port range from the smallest start port number to the
largest end port number when port ranges overlap.
Dell(conf)#inte ra te 2/1 - 11 , te 2/1 - 23
Dell(conf-if-range-te-2/1-23)#
Commas
The following is an example of how to use commas to add different interface types to the range. This example also enables all 10 Gigabit
Ethernet interfaces in the range 5/1 to 5/23 and both 10 Gigabit Ethernet interfaces 1/1 and 1/2.
Dell(conf)# inte ra tengigabitethernet 5/1 - 23, tengigabitethernet 5/1 - 2
Dell(conf-if-range-te-1/1-2,te-5/1-23)#no shutdown
Dell(conf-if-range-te-1/1-2,te-5/1-23)#
`
Add Ranges
The following example shows how to use commas to add VLAN and port-channel interfaces to the range.
Dell(conf)#int range te5/1-23 , te1/1 - 2
Dell(conf-if-range-te-1/1-2,te-5/1-23)#interface range vlan 2 - 100 , Port 1 - 25
Dell(conf-if-range-vl-2-100,po-1-25)#
Interface Range Enhancements
Inserting a space between comma-separated interfaces and interface ranges in interface range command syntax is no longer
required.
For example, you can enter the following valid interface range: interface range fo 2/0-16,te 1/0,te 0/0–3,fo 0/4.
414
Interfaces