Administrator Guide

• interface interface — Enter the interface keyword and specify the PE Gigabit Ethernet interface using the keyword
peGigE or peTenGigE. Specify a pe-id/unit/port for the interface.
Example of Displaying Allocated Power to Power Devices
Stack unit in pe to which this config applies
Dell#show power inline pe 2 stack-unit 1
Global inline power Threshold : 90%
Power Reserved for inline Power: 1530W
Total Inline Power Consumed: 15W
Remaining inline power Available: 1515W
Power Management Mode: Static
Interface Inline Power Inline Power Class Device PoE Port LLDP
Max / Alloc Consumed Type Priority Support
Watts) (Watts)
--------- ------------- ------------ ----- ------ -------- -------
PeGi 2/1/2 30.00 / 15.00 15.00 4 2 Low PowViaMDI
Table 75. show power inline Field Description
Field Description
Interface Displays the linecard slot and port number.
Inline Power Max /
Alloc
Displays the maximum amount of power allowed for the port currently allocated to the port when sufficient
power is available. When sufficient power is not available for a particular port, inline power is not supplied to
that port. If you insert an extra power supply, or when the priority of the port is sufficiently increased, the PSU
the allocated power to the port.
Inline Power Consumed Displays the amount of power that the connected device consumes.
Class Displays the power classification of the connected device. If the device is powered up properly, it displays,
Class 0, 1, 2, 3, or 4.
• NO_DEVICE — if no device is present
• LEGACY — if a legacy device is connected.
• PD_S/C — if a short-circuit condition is detected.
• PD_OVRLD — if overload condition is detected.
NOTE: After device detection, the Class value received via 802.3 Power via MDI takes
precedence and displays here.
Device Type Displays whether the device is Type 1 or Type 2.
NOTE: After device detection, the Type value received via 802.3 Power via MDI takes
precedence and displays here.
PoE Port Priority Displays the priority assigned for the port (the default is low). See Allocating PoE Power on an Interface.
NOTE: You can configure priority or it is received via 802.3 Power via MDI. The user-configured
priority always takes precedence. See the power inline priority command in the Power
Over Ethernet (PoE) chapter of the Dell Networking OS Command Reference Guide .
LLDP Support Displays whether the power requested is via LLDP-MED extended power-via-mdi TLV (displays as “LLDP-
MED”) or IEEE 802.3at power-via-mdi TLV (displays as “PowViaMDI”).
Displaying Power Consumption on the Port Extender
To display detailed inline power consumption on a port extender, use the following command.
For more information on monitoring power budget, see Monitoring the Power Budget.
• Display detailed information about inline power consumption on the port extender.
EXEC mode
show power detail {pe pe-id stack-unit unit-number}
Power over Ethernet (PoE)
731