Concept Guide
Enabling GVRP Globally
To congure GVRP globally, use the following command.
• Enable GVRP for the entire switch.
CONFIGURATION mode
gvrp enable
Example of Conguring GVRP
Dell(conf)#protocol gvrp
Dell(config-gvrp)#no disable
Dell(config-gvrp)#show config
!
protocol gvrp
no disable
Dell(config-gvrp)#
To inspect the global conguration, use the show gvrp brief command.
Enabling GVRP on a Layer 2 Interface
To enable GVRP on a Layer 2 interface, use the following command.
• Enable GVRP on a Layer 2 interface.
INTERFACE mode
gvrp enable
Example of Enabling GVRP on an Interface
Dell(conf-if-te-1/21)#switchport
Dell(conf-if-te-1/21)#gvrp enable
Dell(conf-if-te-1/21)#no shutdown
Dell(conf-if-te-1/21)#show config
!
interface TenGigabitEthernet 1/21
no ip address
switchport
gvrp enable
no shutdown
To inspect the interface conguration, use the show config command from INTERFACE mode or use the show gvrp interface
command in EXEC or EXEC Privilege mode.
Congure GVRP Registration
Congure GVRP registration.
There are two GVRP registration modes:
• Fixed Registration Mode — guring a port in xed registration mode allows for manual creation and registration of VLANs, prevents
VLAN deregistration, and registers all VLANs known on other ports on the port. For example, if an interface is statically congured via
the CLI to belong to a VLAN, it should not be uncongured when it receives a Leave PDU. Therefore, the registration mode on that
interface is FIXED.
• Forbidden Mode — Disables the port to dynamically register VLANs and to propagate VLAN information except information about
VLAN 1. A port with forbidden registration type thus allows only VLAN 1 to pass through even though the PDU carries information for
more VLANs. Therefore, if you do not want the interface to advertise or learn about particular VLANS, set the interface to the
registration mode of FORBIDDEN.
418
GARP VLAN Registration Protocol (GVRP)