Concept Guide
NOTE: To locate a 4x10G port, enter the system location-led interface {fortyGigE | tengigabitethernet}
slot/port on command. The 4x10G port LED turns solid blue.
Figure 51. 1/10GbE SFP+ Port Numbering
On the 1/10GbE SFP+ line card, ports are numbered from 0 to 23 and operate in 1/10G mode.
Figure 52. 1/10GbE RJ-45 Port Numbering
On the 1/10GbE RJ-45 line card, ports are numbered from 0 to 23 and operate in 1/10G mode.
Figure 53. C1048P Port Numbering
On a C1048P port extender, 10/100/1000BASE-T ports on the front panel are numbered from 1 to 48.
• Odd-numbered ports 1-47 are on top; even-numbered ports 2-48 are on the bottom.
• A yellow PE port number indicates that the port is PoE-enabled.
• The two 10GbE SFP+ ports, which are used only for uplinks to an attached C9010, are numbered 1 and 2.
After the initial PE provisioning is performed, you can congure L2 and other software features by entering CLI commands on the C9010
console. C1048P interfaces are identied in the command syntax:
Interfaces
441